HP P2000 G3 MSA Reference Manual page 39

249
Info. After a valid license is installed, this event is logged for each licensed feature to show the new license
value for that feature. The event specifies whether the feature is licensed, whether the license is temporary,
and whether the temporary license is expired.
Recommended actions
• No action is required.
250
Warning A license could not be installed.
The license is invalid or specifies a feature that is not supported on your product.
Recommended actions
• Review the readme file that came with the license. Verify that you are trying to install the license on the
system that the license was generated for.
251
Info. A volume-copy operation has started for the indicated source volume.
If the source volume is a master volume, you can remount it.
If the source volume is a snapshot, do not remount it until the copy is complete (as indicated by event 268).
Recommended actions
• No action is required.
252
Info. Data written to the indicated snapshot after it was created has been deleted. The snapshot now represents
the state of the master volume when the snapshot was created.
Recommended actions
• No action is required.
253
Info. A license was uninstalled.
Recommended actions
• No action is required.
255
Info. The PBCs across controllers do not match as PBC from controller A and PBC from controller B are from
different vendors. This may limit the available configurations.
Recommended actions
• No action is required.
256
Info. The indicated snapshot has been prepared but is not yet committed.
This can occur when a snapshot has been prepared but is not yet committed. This can occur when a
snapshot is taken by an application, such as the VSS hardware provider, that is timing-sensitive and needs
to take a snapshot in two stages.
After the snapshot is committed and event 258 is logged, the snapshot can be used.
Recommended actions
• No action is required.
HP P2000 G3 MSA System Event Descriptions Reference Guide 39