Horizontal Vent Shield Installation; 800-Wpt / #800-Wpt-2 Wall Pass-Thru Installation - kozy heat Two Harbors 55616 Installation And Operation Manual

HORIZONTAL VENT HEAT SHIELD INSTALLATION
IMPORTANT: THE HORIZONTAL VENT HEAT SHIELD MUST BE INSTALLED WHEN USING A 90-DEGREE ELBOW TO
HORIZONTALLY POSITION VENT SYSTEM.
1. Install 90-degree elbow per manufacturer‟s installation instructions.
2. Loosen, but do not remove (2) screws at top of fireplace.
3. Slide (2) slots on horizontal vent heat shield under screws. Re-tighten screws to secure in place.
Figure 17a
#800-WPT / #800-WPT2 WALL PASS-THRU KITS INSTALLATION
IMPORTANT: KOZY HEAT WALL PASS-THRU, PART #800-WPT (4-1/2" (114mm) - 6-1/2" (165mm) ) WALL THICKNESS OR
#800-WPT2 (6-1/2" (165mm) - 12-1/2" (318m) ), MUST BE USED ON ALL HORIZONTAL VENT RUNS.
FRAMING DIMENSIONS FOR KOZY HEAT WALL PASS-THRU KITS
12-1/2" (318mm) HIGH x 10-7/8" (276mm) WIDE
WARNING: MAINTAIN ALL CLEARANCES AS STATED IN THIS INSTALLATION MANUAL.
A. Measure wall thickness; cut insulation panel (included) this
length.
B. Install wall pass-thru section marked #1 (with 3/8" (10mm)
flange) into framed opening. Secure to interior wall with
screws (not provided).
C. From the exterior, place insulation between flange and top
of framed opening in wall pass-thru section #1.
D. Install section marked #2 of wall pass-thru into framed
opening, overlapping metal sections as necessary to
accommodate wall thickness. Secure to exterior wall with
screws (not provided).
VENTING
Loosen, but do not remove screws.
PAGE 17
3/8" (10mm) FLANGE MUST BE
ON INSIDE WALL.
HEAT SHIELD MUST BE FLUSH
WITH WALL PASS -THRU.
Figure 17b
Slide slots under screws. Tighten screws.
INSULATION