To Adjust The Boundary Between Black And Colors Other Than Black - Toshiba e-STUDIO 2500c Manual

2.16.3 To Adjust the Boundary between Black and Colors other than Black

* Both the service technician and the user can use procedures (1) and (2).
* Only the service technician must use procedure (3).
(1) Press the [IMAGE] button on the Control Panel. Press the [TWIN COLOR COPY] button.
Press the [RED&BLACK] button to enter the Red and black mode.
Use procedure (2).
(2) Press the [ADJUST] button. Press the [ ] button or the [ ] button for Range Adjustment, in order to
adjust the boundary between red and black.
• [ ] "RED":
• [ ] "BLACK":
After adjusting the boundary, copy and check the copy image quality.
If further image quality adjustments are still necessary, the service technician must use the next procedure.
(3) Enter adjustment mode [05]. Change the values for codes [7641/7642] to adjust the boundary between
black and colors other than black.
* As the set value is increased, the area of "CHANGE BLACK TO" will become larger. On the other hand,
if the value is decreased, the area of "SECOND COLOR" will become larger.
Mode to adjust
Red and black mode
Twin color – Red and black mode
("RED" selected in Twin color selectable
mode)
* The subcode varies according to the area where the density is adjusted. Refer to the table below and set
the subcode for the area to be adjusted.
Subcode
0
1
2
Precautions after the completion of the adjustment
Nothing in particular.
The black area decreases and the red area increases.
The black area increases and the red area decreases.
[05] code
05-7641
05-7642
Area where the density is adjusted
High-density area
Medium-density area
Low-density area
2. Copier-specific Adjustments
Recommended
Subcode
value
0/1/2 0 to 255
e-STUDIO2500c/3500c/3510c
Default
128
2.16