Toshiba e-STUDIO 2500c Manual page 80

2. Copier-specific Adjustments
(4) Enter adjustment mode [05]. Change the values for codes [1780/1785/1790/1795] or [1783/1788/1793/1798]
to adjust the color density.
Color to
adjust
Y
(Yellow)
M
(Magenta)
C
(Cyan)
K
(Black)
* Set the value in increments of approximately 10, while checking the copy image until the optimum value
is obtained.
* The subcode varies according to the area where the density is adjusted. Refer to the table below and set
the subcode for the area to be adjusted.
Subcode
0
1
2
Precautions after the completion of the adjustment
The adjustment may possibly cause a dark-colored area, such as in a photo, to become blurred on the copy. Also,
it may also cause offset failure, grained images and degradation in gradation. Therefore, carefully perform the
adjustment, while checking the copy image.
2.11
e-STUDIO2500c/3500c/3510c
Original mode [05] code Subcode
Text 05-1780
Map 05-1783
Text 05-1785
Map 05-1788
Text 05-1790
Map 05-1793
Text 05-1795
Map 05-1798
Area where the density is adjusted
Low-density area
Medium-density area
High-density area
Recommended value
0/1/2
0/1/2
0/1/2
0/1/2
Set a value larger than 128.
0/1/2
0/1/2
0/1/2
0/1/2
Acceptable
Default
value range
0 to 255 128