Toshiba e-STUDIO 2500c Manual page 27

(2) Check the life of the consumables (particularly the drum, developer material and transfer belt unit) and
replace them, if necessary.
• When replacing any consumable, use steps (a) to (c).
(a) Enter the PM support mode. Reset the counter corresponding to the replaced consumable to "0."
* For further information regarding the PM support mode, refer to the Service Handbook.
(b) Enter adjustment mode [05]. Select code [396]. Press the [START] button.
• Image quality control will be performed and the image quality control value will be initialized.
(c) Perform automatic calibration.
* For further information regarding the procedures, refer to procedure (2) in 1.1 To Obtain a Darker
Image.
* After replacing any consumable, remember to reset the counter corresponding to it to "0." Otherwise, it
may cause a loss in MFP performance, including degradation in the image quality and a reduction in the
life of the consumables.
* While replacing any consumable, also check the slit glass in the laser optical unit, and thoroughly clean it,
if it is soiled.
Precautions after the completion of the adjustment
The adjustment may possibly slow down the copying or printing speed, extend the warm-up time when the MFP
is returned from the auto power save mode, and shorten the life of the consumables, because of an increase in the
number of times image quality control is performed. Therefore, carefully perform the adjustment, while
checking the copy or print image.
Remarks
• Enter the value mentioned in the procedures or one within the recommended value range for the adjustment.
Otherwise, it may cause a loss in MFP performance, including slowdown in the copying or printing speed.
• When replacing any consumable, refer to the relevant information in the Service Manual and Service Handbook.
1. General Adjustments – Copying, Printing and e-Filing (Output from Box)
e-STUDIO2500c/3500c/3510c
1.4