Toshiba e-STUDIO 2500c Manual page 12

1. General Adjustments – Copying, Printing and e-Filing (Output from Box)
(3) Enter adjustment mode [05]. Change the values for codes [2934 to 2937] to adjust the transfer (2nd
transfer) roller bias output.
(Adjust the offset voltage of transfer roller bias so as to increase the density of the image.)
• The code to use varies according to the paper type. Adjust the value for [05] code corresponding to the
paper type for which you would like to improve the image quality. Set the value within a range of "2" to
"8" to obtain the highest density of the image.
Paper type
Full color
Black
* "Front" refers to the printed side in the simplex mode or the side that is delivered facing upwards in the duplex mode.
"Back" refers to the printed side that is delivered facing downwards in the duplex mode.
* The table below shows you the acceptable paper weight for the paper type.
Paper type
Plain paper
Thick 1
Thick 2
Thick 3
• After adjusting the transfer roller bias output, perform automatic calibration in the same manner as in
procedure (2).
1.1
e-STUDIO2500c/3500c/3510c
[05] code
Plain paper
Thick 1
Thick 2
Thick 3
Front 05-2934
OHP
Special 1
Special 2
Recycled paper
Plain paper
Thick 1
Thick 2
Thick 3
Back 05-2935
OHP
Special 1
Special 2
Recycled paper
Plain paper
Thick 1
Thick 2
Thick 3
Front 05-2936
OHP
Special 1
Special 2
Recycled paper
Plain paper
Thick 1
Thick 2
Thick 3
Back 05-2937
OHP
Special 1
Special 2
Recycled paper
Acceptable paper weight
64 to 105 g/m²
106 to 163 g/m²
164 to 209 g/m²
210 to 256 g/m²
Recommended
Subcode
value
0
1
2
3
2 to 8
4
5
6
7
0
1
2
3
2 to 8
4
5
6
7
0
1
2
3
2 to 8
4
5
6
7
0
1
2
3
2 to 8
4
5
6
7
16 to 20 lb. Bond
Max. 60 lb. Cover
Max. 110 lb. Index
Max. 140 lb. Index
Acceptable
Default
value range
0 to 10 5
0 to 10 5
0 to 10 5
0 to 10 5