Toshiba e-STUDIO 2500c Manual page 152

3. Printer-specific Adjustments 3.
PCL6 PS3
(5) Enter adjustment mode [05]. Increase the values for codes [8110 to 8117] to perform fine adjustment and
increase the sharpness intensity.
• Adjust the value for [05] code corresponding to the print option to be applied (PDL, Color mode, and
Image quality type).
* Printing on Macintosh is performed in PostScript. (See the "PS3" row in the table below.)
PDL Color mode
PS3 Auto/Color
PCL6 Auto/Color
* Set the value in increments of approximately 5, while checking the printouts until the optimum value is
obtained.
<Hint>
This adjustment affects on the following areas according to Image Quality Type:
<Note> • This adjustment changes the values set in the MFP. Therefore, it will affect every user who
uses the printer by connecting it to the MFP. After the adjustment, the values changed will be
applied to all printouts for the "Sharpness" option. Carefully perform the adjustment, being
aware that the image quality of all future printouts will be changed, when printing out originals
other than the one that is used for the adjustment.
• The code in Standard Auto/Color mode is commonly used in the Twin-color mode. After the
adjustment, the values changed will be also applied to the image quality in the Twin-color
mode. When adjusting the image quality in Standard mode, carefully perform the adjustment,
being aware that the image quality of all future printouts will be changed, when performing
printing in the Twin-color mode.
Precautions after the completion of the adjustment
The adjustment may possibly cause outlined edges, incorrect color of thin lines, jaggies, and variations in
gradation. As a result the photo image may look unnatural. Therefore, carefully perform the adjustment, while
checking the printouts.
3.14 3.14
e-STUDIO2500c/3500c/3510c
* This adjustment will have an effect only on Auto or Color mode printing.
Mac
Image
quality type
General
Photograph
Presentation
Line Art
General
Photograph
Presentation
Line Art
• General, Photograph, and Presentation: Only raster data (print image)
• Line Art:
Recommended
[05] code
value
05-8110
05-8111
05-8112
05-8113
Set a value lager
than 128
05-8114
05-8115
05-8116
05-8117
Only thin lines, small text and raster data
Acceptable
Default
value range
0 to 255 128