Toshiba e-STUDIO 2500c Manual page 86

2. Copier-specific Adjustments
(3) Enter adjustment mode [05]. Change the values for codes [1779 to 1798] to adjust the color density.
Color to
adjust
Y
(Yellow)
M
(Magenta)
C
(Cyan)
K
(Black)
* Set the value in increments of approximately 10, while checking the copy image until the optimum value is
obtained.
* The value for the code corresponding to the original mode (Text/Photo, Text, or Printed image) will affect
the copy image quality in the Full color mode and the Auto color mode.
* The subcode varies according to the area where the density is adjusted. Refer to the table below and set
the subcode for the area to be adjusted.
Subcode
0
1
2
2.13
e-STUDIO2500c/3500c/3510c
Original mode [05] code Subcode
Text/Photo 05-1779
Text 05-1780
Printed image 05-1781
Photo 05-1782
Map 05-1783
Text/Photo 05-1784
Text 05-1785
Printed image 05-1786
Photo 05-1787
Map 05-1788
Text/Photo 05-1789
Text 05-1790
Printed image 05-1791
Photo 05-1792
Map 05-1793
Text/Photo 05-1794
Text 05-1795
Printed image 05-1796
Photo 05-1797
Map 05-1798
Area where the density is adjusted
Low-density area
Medium-density area
High-density area
Recommended value
0/1/2
0/1/2
0/1/2
0/1/2
0/1/2
0/1/2
0/1/2
0/1/2
Set a value larger than 128
0/1/2
to increase the density.
0/1/2
0/1/2
Set a value smaller than 128
0/1/2
to decrease the density.
0/1/2
0/1/2
0/1/2
0/1/2
0/1/2
0/1/2
0/1/2
0/1/2
Acceptable
Default
value range
0 to 255 128