3: Multiband Limiter - Korg HAVIAN 30 User Manual

f: Trigger Monitor
Setting this parameter On will cause the trigger signal to be output, instead
of the effect sound. Use this parameter to check the trigger signal with EQ
applied.
Usually, set this to Off.
f: Side PEQ Insert
g: Side PEQ Cutoff [Hz]
g: Q
g: Gain [dB]
These parameters are used to set the EQ applied to the trigger signal.
The Limiter determines whether the compression is applied or not, based on
the post-EQ trigger signal. Setting the equalizer allows you to set the Limiter
to respond to any frequency band.

3: Multiband Limiter

This effect applies the Limiter to the low range, mid range, and high range
of the input signal. You can control dynamics for each range to adjust the
sound pressure of the low range, mid range, and high range in a different
way from the EQ.
FX Amt = 100: Mono In - Mono Out / FX Amt = 0: Stereo In - Stereo Out
Left
Band-Pass Filters
Low
Mid
+
High
Right
a Ratio
b Threshold [dB]
c Attack
d Release
e Low Offset [dB]
f Mid Offset [dB]
Limiter
Envelope - Control
Low Offset
Limiter
Envelope - Control
Mid Offset
Limiter
Envelope - Control
High Offset
1.0 : 1...50.0 : 1,
Inf : 1
–40...0
1...100
1...100
–40...0
–40...0
Dynamics (Dynamic) |407
FX Amt
Gain Adjust
FX Amt
Sets the signal compression ratio
Sets the level above which the com-
pressor is applied
Sets the attack time
Sets the release time
Gain of the low-range trigger signal
Gain of the mid-range trigger signal