Table of Contents
Advertisement
Step 1: Mount the Feet
The modem comes with a strip of self-adhesive plastic feet, which you can optional-
ly mount on the bottom of the modem. To install the feet, simply peel them from
their paper strip and press them into the recesses on the bottom of the modem.
Figure 2-1. Mounting the feet.
Step 2: Select Stereo or Mono Speaker
If you want to connect a monophonic external speaker to the MessageSaver, you
must open the modem case and change a jumper. If you want to connect a stereo ex-
ternal speaker or sound card, or to have no external sound connection at all, you
may skip this step and proceed to Step 3.
Caution: The circuit board can be harmed by static electricity. Before you open the
case, touch a grounded object such as a water faucet to discharge any static electrici-
ty in your body, then touch the metal shell of the modem's RS232 connector to en-
sure that there is no voltage difference between you and the modem.
Warning: The following procedure must be performed by authorized service per-
sonnel.
Opening the Modem
1. If the modem is connected, turn it off and remove all connecting cables, includ-
2. Turn the modem over.
3. On the bottom of the modem are two screws that hold the case together. Re-
4. Turn the modem over again.
5. Remove the top part of the modem case.
6. To close the modem, reverse steps 1–5.
ing power and line cables.
move both screws and set them aside.
2 Quick Start
7
Advertisement
Table of Contents
