Table of Contents
Advertisement
MessageSaver User Guide
Command:
Values:
Default:
Description:
Command:
Values:
Default:
Description:
Command:
Values:
Default:
Description:
Command:
Values:
Default:
Description:
Command:
Values:
Default:
Description:
32
V Switch to speakerphone mode and dial the following num-
ber. Use ATH command to hang up.
W Wait for a new dial tone before continuing to dial. (X2, X4,
X5, X6, or X7 must be selected.)
,
Pause during dialing for time set in register S8.
;
Return to command mode after dialing. (Place at end of
dial string.)
Hook flash. Causes the modem to go on-hook for one-half
!
second, then off-hook again.
Wait for quiet answer. Causes modem to wait for a ring-
@
back, then 5 seconds of silence, before processing next part
of command. If silence is not detected, the modem returns
a NO ANSWER code.
^
Disable data calling tone transmission.
$
Detect AT&T call card "bong" tone. The character should
follow the phone number and precede the user's call card
number: ATDT1028806127853500$123456789
DS= y Dial Stored Telephone Number
y = 0–3
none
Dial a number previously stored in directory number y by the
&Zy=x command. Example: ATDS=3.
E n
Echo Command Mode Characters
n = 0 or 1
1
E0
Do not echo keyboard input to the terminal.
E1
Do echo keyboard input to the terminal.
F n
Echo Online Data Characters
n = 1
1
F0
Enable online data character echo. (Not supported.)
F1
Disable online data character echo (included for backward
compatibility with some software).
H n
Hook Control
n = 0 or 1
0
H0
Go on-hook (hang up).
H1
Go off-hook (make the phone line busy).
I n
Information Request
n = 0–5, 9, 11
None
I0
Display default speed and controller firmware version.
I1
Calculate and display ROM checksum (e.g., 12AB).
I2
Check ROM and verify the checksum, displaying OK or ERROR.
I3
Display default speed and controller firmware version.
I4
Display firmware version for data pump (e.g., 94).
Advertisement
Table of Contents
