Table of Contents
Advertisement
MessageSaver User Guide
Command:
Values:
Default:
Description:
Command:
Values:
Defaults:
Description:
Command:
Values:
Defaults:
Description:
Command:
Values:
Description:
Command:
Values:
Default:
Description:
Command: %DC n AT Command Control
Values:
Default:
Description: %DC0 The modem responds to AT commands.
Note: The modem will respond to AT%DC for 10 seconds after power-up.
Command:
Values:
Default:
Description:
40
\V n
Protocol Result Code
n = 0, 1, or 2
1
\V0
Disable the appending of the protocol result code to the DCE
speed.
\V1
Enable the appending of the protocol result code to the DCE
speed.
\V2
Same as \V1.
\X n
XON/XOFF Pass-Through
n = 0 or 1
0
\X0
Modem responds to and discards XON/XOFF characters.
\X1
Modem responds to and passes XON/XOFF characters.
-C n
Data Calling Tone
n = 0 or 1
0
-C0
Disable V.25 data calling tone to deny remote data/fax/voice
discrimination.
-C1
Enable V.25 data calling tone to allow remote data/fax/voice
discrimination.
%B
View Numbers in Blacklist
n/a
If blacklisting is in effect, AT%B displays the numbers for
which the last call attempted in the previous two hours failed.
In countries that do not require blacklisting, the ERROR result
code appears.
%C n Data Compression Control
n = 0 or 1
1
%C0 Disable V.42bis/MNP 5 data compression.
%C1 Enable V.42bis/MNP 5 data compression.
n = 0 or 1
0
%DC1 The modem ignores AT commands.
%E n Fallback and Fall Forward Control
n = 0, 1, or 2
2
%E0 Disable fallback and fall forward.
%E1 Enable fallback, disable fall forward.
%E2 Enable fallback and fall forward.
Advertisement
Table of Contents
