Multitech MessageSaver MT5634MSV User Manual page 42

MessageSaver User Guide
Command:
Values:
Default:
Description:
Command:
Values:
Default:
Description:
Command:
Values:
Default:
Description:
Command:
Values:
Default:
Description:
Command:
Values:
Default:
Description:
Command:
Values:
Default:
Description:
Command:
Values:
Default:
Description:
34
Q n Result Codes Enable/Disable
n = 0 or 1
0
Q0 Enables result codes.
Q1 Disables result codes.
Q2 Returns an OK for backward compatibility with some soft-
ware.
S r = n Set Register Value
r = S-register number; n varies
None
Set value of register Sr to value of n, where n is entered in deci-
mal format. E.g., S0=1.
S r ? Read Register Value
r = S-register number
None
Read value of register Sr and display it in 3-digit decimal form.
E.g., S2? gives the response 043.
T Tone Dialing
P, T
T
Configures the modem for DTMF (touch-tone) dialing. Dialed
digits are tone dialed until a P command or dial modifier is
received.
V n Result Code Format
n = 0 or 1
1
V0 Displays result codes as digits (terse response).
V1 Displays result codes as words (verbose response).
W n Result Code Options
n = 0, 1, or 2
2
W0 CONNECT result code reports serial port speed, disables pro-
tocol result codes.
W1 CONNECT result code reports serial port speed, enables pro-
tocol result codes.
W2 CONNECT result code reports line speed, enables protocol re-
sult codes.
X n
Result Code Selection
n = 0–7
4
X0 Basic result codes (e.g., CONNECT); does not look for dial tone
or busy signal.
X1 Extended result codes (e.g., CONNECT 46000 V42bis); does not
look for dial tone or busy signal.
X2 Extended result codes with NO DIALTONE; does not look for
busy signal.