MATERIAL LIST
.46-.60 size ProX260
Fuselage – covered, nose of fuse fuel-proofed:
pre-drilled holes for the tail wheel assembly:
pre-drilled holes for main landing gear mounting
pre-drilled hole for wing tube
pre-drilled holes for anti-rotation pins of wing
pre-cut slot for the stab mounting
pre-cut slot on top of fuse for fin tab mounting
pre-cut and covered throttle servo mounting holes -
(1) for 2 stk and (1) for 4 stk.
pre-cut with covering removed cut outs for the
servos in the tail
Left Wing with Aileron – covered: Pre-drilled for the
KIT CONTENTS
.46-.60 ProX260
mounting of the control horns. Pre-cut hole - Covered
- in bottom of wing for the servo
Aileron is in place with (5) CA hinges not glued
Servo Hatch Cover in place with (2) nylon small latch
hatch
(2) 4-40 blind nuts pre installed at wing tip for
installing the side force generators
Right Wing with Aileron – covered: Pre-drilled for the
(1) Aileron is in place with (5) CA hinges not glued
(2) 4-40 blind nuts pre installed at wing tip for in-
(1) 8-32 blind nut pre installed for the wing
5
mounting of the control horns. Pre-cut hole -
Covered – in bottom of wing for the servo
extension.
Servo Hatch Cover in place with (2) nylon small
latch hatch
stalling the side force generators
mounting
extension.