Table of Contents
Advertisement
VERTICAL FIN/RUDDER INSTALLATION
1. Mix 30 Minute Epoxy and brush onto the ex-
posed portion of the rear post and reinforcement
tab on the vertical fin as shown.
2. Insert vertical fin back in fuse and double check
alignment. Allow the Epoxy to dry before con-
tinuing.
Note: Clean off excess epoxy using rubbing
alcohol.
(.46-.60 Tail Wheel Installation)
20
46-60 SIZE ONLY
3. Use 30minute epoxy to secure the steering arm
inside the precut slot in the rudder as shown.
Note: If building the .60-.90 size ProX260 skip to
step 4
4. Pin each CA hinge using the same method that
was used for the wings.
5. Install the hinges into the rudder and vertical fin
and remove the pins. Use thin CA to glue the
hinges in place.
Note: Always use a fresh bottle of CA. Old CA will
not cure and can cause failure.
Hide quick links:
Advertisement
Table of Contents
