Table of Contents
Advertisement
5. Install the brass servo eyelets in the servos with
the flanges towards the top of the case as shown
below.
Note: Trim the servo mounting screws to ensure
they will not
pass through the
top of the wing
when installed.
6. Install servo in the servo bay inside the wing.
Ensure that the output shaft is towards the trail-
ing edge of the wing.
7. Ensure the output shaft is centered in the hole as
shown.
Control Horn Installation
1. Gather the aileron control horn parts as shown
below.
◊
2 - Nylon control horns
◊
2 - Base plates
◊
4 - 2x25mm Phillips head mounting bolts.
14
Hide quick links:
Advertisement
Table of Contents
