Troubleshooting - Vello freewave fusion User Manual

TROUBLESHOOTING

Problems with the FreeWave Fusion can
usually be traced to common causes.
Perform the following steps to diagnose and
correct the problem:
Check the contact between the light's hot
shoe foot and the Receiver's hot shoe. Make
sure the light's locking switch is set to the
lock position.
Check that the shutter release cable and/or
studio light cable are in good condition and
properly connected.
Make sure that the Receiver is powered
on and at the correct setting.
Remove the batteries from the Transmitter
and Receiver, and change the channel by
rearranging the DIP switches to a different
combination, taking care to ensure that
both the Transmitter and Receiver are set
identically.
If you encounter any interference on the
initial setting, try changing the channel by
choosing a different DIP switch combination.
When using the FreeWave Fusion as a
shutter release, your camera may not be
able to release the shutter if the lens is set
to Auto Focus and focus cannot be achieved
on subject. Switch your camera to manual
focus to ensure proper shutter release.
21