Mounting A Flash To The Flashboss - Vello Flashboss User Manual

MOUNTING A FLASH TO THE FLASHBOSS

A flash can be mounted
onto the FlashBoss when the
FlashBoss is attached to the
camera. In this configuration,
the FlashBoss can operate as
a transmitter or receiver.
The FlashBoss TTL pass-through
capability allows the TTL
metering data to flow from the
camera, through the FlashBoss,
and directly to the flash.
A flash and FlashBoss can also be
used for remote operation with
the FlashBoss in receiver mode.
14
Make sure the FlashBoss
and your flash are turned
off before proceeding.
Mount the flash to the
FlashBoss's hot shoe, and
turn on the flash.
Important! Make sure the flash
is set to TTL mode in order
to function properly with the
FlashBoss's operating modes. Refer
to your flash's manual for enabling
TTL mode.