The Navigator; Sleep Mode; Reset Functions - VDO X2 Instruction Manual

GB SLO PL JP

5.7 The navigator

With the VDO navigator you can complete trips
according to Roadbooks. Roadbooks = tour
descriptions with km information for certain
points of orientation. The VDO navigator is an
independent km counter and can count forwards
or backwards. The km status can be set at any
desired point. You can therefore start in the
middle of a trip or make a km correction if you
have taken a wrong turn.
Setting the navigator:
Using go to NAVIGATOR/
SELECT. Confirm with M .
NAVIGATOR/SET. Confirm with
You are now in setting mode
(pressing C for 3 seconds gets
you back to function mode).
Select NAVIGATOR/FORWARD or
NAVIGATOR/BACKWARD using
. Confirm with M .
16 X2
NAVIGATOR SET DISTANCE/
CONTINUE. The flashing digit is
ready to be set. Using
the digits. Access next digit with
M . Repeat steps until last digit is
flashing. Confirm with
NAVIGATOR/SET OK? Confirm with M .
NAVIGATOR/SET DONE appears as confirmation
and your VDO computer automatically returns to
the NAVIGATOR/SELECT menu.
Note: The navigator always runs automatically at
the same time, even if you have not set it.
Set navigator back to zero:
.
M
Using go to NAVIGATOR/SE-
LECT. Confirm with
NAVIGATOR/SET
Using switch to
NAVIGATOR/RESET.
Confirm with M .
Security question: NAVIGATOR/RESET? Confirm with
NAVIGATOR/SET DONE appears briefly and your
VDO computer automatically returns to the
NAVIGATOR/SELECT start menu.
VDO CYCLECOMPUTING

5.8 Sleep mode

Your VDO computer is equipped with a sleep
mode function.
set In sleep mode, a large part of the display is switched
off to save battery power. Time, service interval
display and the -symbol (if the stopwatch is
M . running) continue to be displayed.

5.9 Reset functions

You use the RESET function to set any of these back
TOUR DATA
B
ODO TOTAL
B
TOT RIDE TM
B
NAVIGATOR
B
With the respective reset modes, the following
information is deleted:
TOUR DATA: Day's tripdistance, ride time,
B
average speed, max. speed
ODO TOTAL: Total km, km bike 1, km bike 2
B
TOTAL RIDE TM: Total ride time, ride time bike 1,
B
M . ride time bike 2.
NAVIGATOR: all values from the second
B
distance counter.
Using
SELECT. Confirm with
You are now in setting mode
(pressing
M . you back to function mode).
www.vdocyclecomputing.com
Sleep mode switches itself on after 5 minutes if
no speed impulses are processed and no button
is pressed.
Sleep mode is ended when speed impulses are
processed again (when cycling) or a button is
pressed.
go to SETTINGS/
M . ATTENTION: This step cannot be reversed.
C for 3 seconds gets Only confirm with
selected data. The display confirms:
DATA RESET/RESET DONE.
Automatic return to SETTINGS/SELECT.
JP PL SLO GB
Using go to DATA RESET/
SELECT. Confirm with M .
Use to go to the data you
want to reset:
DATA RESET/TOUR DATA
B
DATA RESET/TOT RIDE TM
B
DATA RESET/ODO TOTAL
B
DATA RESET/NAVIGATOR
B
Confirm your selection with M .
Query: SELECTED DATA/RESET?
M , if you want to delete the
X2 17