Setting Using Wheel Circumference; Setting The Clock; Setting The Total Kilometres - VDO X2 Instruction Manual

GB SLO PL JP

5.2.2 Setting using wheel circumference

To enter the wheel size manually, you must first
measure the wheel roll circumference on your bike.
Measuring wheel roll circumferences:
step 1 Precisely align valve on the front wheel
vertically to the ground.
Step 2 Mark this spot on the ground with a line
(e.g. chalk).
step 3 Push the bike forwards one turn of the wheel
until the valve is vertical to the ground again.
Step 4 Also mark this spot on the ground.
Step 5 Measure the distance between the two
marks.That is your wheel circumference
(=roll circumference).
Step 6 Enter the wheel circumference measured
in this way into your VDO computer.
ATTENTION: If you have selected KMH display,
you must enter the wheel circumference in mm
(If MPH display is selected, enter the wheel
circumference in inches).
How to set the wheel size manually:
Using go to SETTINGS/
SELECT. Confirm with M
You are now in setting mode
(pressing for 3 seconds gets
C
you back to function mode)
12 X2
>>> P05
Using go to WHEELSIZE/
SET. Confirm with M .
MEASUREMENT/KMH.
Confirm with M or to
change to MPH.
WHEELSIZE/BIKE 1.
(use to go to setting for
bike 2) Confirm with M .
Using go to
WHEEL-SIZE/MANUAL SET.
Confirm with M .
BIKE 1 ...SET SIZE/CONTINUE
Now set the wheel roll circum-
ference measured using
Confirm the entry with M .
BIKE 1/SET OK? Confirm with M .
The display confirms: WHEELSIZE/SET DONE.
Automatic return to SETTINGS/SELECT.
VDO CYCLECOMPUTING
Attention: The factory settings for bike 1 = 2155
mm and for bike 2 = 2000 mm. If you do not enter
any wheel sizes, the computer works with these

5.3 Setting the clock

How to set the clock:
Using go to SETTINGS/
SELECT. Confirm with
You are now in setting mode
(pressing C
you back to function mode)
Using go to CLOCK/SET.
Confirm with
CLOCK/24-H-MODE (you can
switch to 12-H mode using
Confirm with

5.4 Setting the total kilometres

. You can program the values on the distance coun-
ter at any time (e.g. at the end of a season).
Using go to SETTINGS/
SELECT. Confirm with
You are now in setting mode
(pressing
C
you back to function mode).
www.vdocyclecomputing.com
factory settings. The values measured in this
way for speed, distance etc. can differ widely
from the actual values.
M . CLOCK...SET HOUR/CONTINUE
Set the hours using
for 3 seconds gets Confirm the hour setting
with
CLOCK...SET MINUTES/
CONTINUE. Set the minutes
using
M . minutes setting with
CLOCK/SET OK? Confirm with
. The display confirms: CLOCK/SET DONE.
M . Automatic return to SETTINGS/SELECT.
M . Using
SET. Confirm with
for 3 seconds gets
JP PL SLO GB
.
.
M
. Confirm the
M .
.
M
go to ODOMETER/
M .
X2 13