Service Interval Display; The Navigator - VDO X2 Instruction Manual

D GB F I

5.6 Service interval display

The VDO service interval display reminds you to
have your bike checked in the workshop.
You can switch the service interval ON or OFF.
You can set separate service intervals for 2 bikes
When the set service interval distance has been
reached:
The -symbol flashes on the display.
B
The information line displays
B
BIKE SERVICE/BIKE 1
You should now either carry out the recommend-
ed bike check yourself or have the bike checked
by your dealer.
Press any button. The text BIKE SERVICE disap-
pears again. After another 50 km the -also dis-
appears. You can also switch off the flashing
symbol. To do so, enter the service interval again.
How to set the service interval:
Using go to SETTINGS/
SELECT. Confirm with M .
You are now in setting mode
(pressing C for 3 seconds gets
you back to function mode).
Using go to BIKE SERVICE/
SET. Confirm with M .
36 X2
BIKE SERVICE/ON (switch to OFF
using ). Confirm with M
BIKE SERVICE/BIKE 1
(use to switch to bike 2)
Confirm with .
M
BIKE 1 ...SET DISTANCE/
CONTINUE. You can set the flash-
ing digits using To access
the next digit, confirm with
Repeat the steps until the last digit on the right
is flashing. Confirm with M .
BIKE 1/SET OK? Confirm with M .
The display confirms: BIKE SERVICE/SET DONE.
Automatic return to SETTINGS/SELECT.
VDO CYCLECOMPUTING

5.7 The navigator

With the VDO navigator you can complete trips
according to Roadbooks. Roadbooks = tour
descriptions with km information for certain
points of orientation. The VDO navigator is an
independent km counter and can count forwards
. or backwards. The km status can be set at any
desired point. You can therefore start in the
middle of a trip or make a km correction if you
have taken a wrong turn.
Setting the navigator:
Using
SELECT. Confirm with
M .
NAVIGATOR/SET. Confirm with
You are now in setting mode
(pressing C
you back to function mode).
Select NAVIGATOR/FORWARD or
NAVIGATOR/BACKWARD using
. Confirm with
www.vdocyclecomputing.com
NAVIGATOR/SET OK? Confirm with
NAVIGATOR/SET DONE appears as confirmation
and your VDO computer automatically returns to
the NAVIGATOR/SELECT menu.
Note: The navigator always runs automatically
at the same time, even if you have not set it.
go to NAVIGATOR/
M . Set navigator back to zero:
.
M
for 3 seconds gets
M .
I F GB D
NAVIGATOR SET DISTANCE/
CONTINUE. The flashing digit
is ready to be set. Using
set the digits. Access next digit
with M . Repeat steps until last
digit is flashing. Confirm with M .
M .
Using go to NAVIGATOR/
SELECT. Confirm with M .
NAVIGATOR/SET
Using switch to
NAVIGATOR/RESET.
Confirm with M .
X2 37