Fuji Xerox ApeosPort-V C5580 User Manual page 263

Fax Signal Method
1
Select an address number or group dial number to which a relay broadcast is registered,
and press the <Start> button.
To perform Multiple Relay Broadcast, repeat this step.
DTMF Method
The following two types are available in the DTMF method: Auto Send and Manual Send.
 Auto Send (Transmitting without picking up the receiver)
1
Select [ ] to display the keyboard on the touch screen and enter in the following format.
Relay station
telephone
number
 Password
A pre-registered 2-digit number
Note • By default, no password is set. For setting a password, contact our Customer Support Center. If a
 Relay station ID
The last two digits of the initiating station address number registered at the relay station
 Address number
An address number for the relay recipients registered at the relay station
The wildcard "*" can also be used.
You can register the above dialing format in an address number to send using the address number. For information on how
to register address numbers, refer to "5 Tools" > "Setup" > "Add Address Book Entry" in the Administrator Guide.
2
Select [+ Add] to perform Multiple Relay Broadcast.
Note • You can specify up to 20 locations for relay recipients.
3
Press the <Start> button.
 Manual Send (Transmitting with picking up the receiver or on-hook)
1
Select the [More Options] tab to display the [More Options] screen.
2
Pick up the telephone receiver, or select [On-
hook (Manual Send/Receive)].
Password
password is not set, you do not need to enter one.
Relay Address
Address
station number
number
ID
Broadcast
4
263