Removing The Ice Maker And The Auger Motor & Crush/Cube Solenoid - KitchenAid KSSC36FKB00 Technical Education

THE AUGER MOTOR & CRUSH/CUBE SOLENOID
Electrical Shock Hazard
Disconnect power before servicing.
Replace all panels before operating.
Failure to do so can result in death or
electrical shock.
NOTE: Sharp edges may be present.
1. Unplug the refrigerator or disconnect the
power.
2. Open the freezer door and remove the ice
maker shelf and the ice bin.
Ice Maker
REMOVING THE ICE MAKER AND
Shelf
Ice Bin
Ice Maker
Auger Assembly
3. To remove the ice maker:
a) Remove the bottom screw from the ice
maker bracket.
Bottom Bracket Screw
b) Loosen the two top ice maker bracket
screws.
c) Lift the brackets at the top of the ice
maker off the screws, disconnect the
electrical harness connector, and re-
move the ice maker.
Top Bracket
Screws
NOTE: When you reinstall the ice maker, make
sure that the end of the water fill tube is posi-
tioned inside the fill cup (see the photo above).
4-16
Water Fill Tube
Inside Fill Cup