KitchenAid KSSC36FKB00 Technical Education page 17

3. Loosen the four 3/8" hex-head screws on
top of both door hinges.
1. Mounting screws
4. Adjust the hinges so that the door gap is
the same distance at the top and bottom.
5. Check the side door gasket gap. Make
sure that the distance is the same at the
top and bottom. Adjust the hinges, as
necessary.
6. Recheck the front door gap spacing to
make sure that it is properly aligned and
even.
7. Tighten the top hinge screws securely.
8. Reinstall the side door trim.
Door Height Adjustment
Use the following steps to adjust the door
height up or down after the doors have been
leveled.
1. Open the freezer or refrigerator door and
locate the hinge assembly at the bottom of
the door.
1. Locking plate
2. Door stop screw
3. Bushing
1
2-5
2. Use an allen wrench and remove the door
stop screw and locking plate from the
bottom door hinge.
3. Use an open-end wrench and turn the
bushing, located under the bottom of the
hinge, to the left to raise the door, or to the
right to lower the door.
4. Replace the locking plate and door stop
screw. Turn the bushing slightly to align
the hinge and locking plate screw holes.