REMOVING THE BIMETAL, THE EVAPORATOR FAN
MOTOR, THE DEFROST HEATER, AND THE EVAPORATOR
Electrical Shock Hazard
Disconnect power before servicing.
Replace all panels before operating.
Failure to do so can result in death or
electrical shock.
NOTE: Sharp edges may be present.
1.
Unplug the refrigerator or disconnect the
power.
2.
Open the freezer door.
3.
Remove the freezer shelves that are over
the evaporator cover.
4.
Remove the indicated two shelf mounting
studs.
5.
Remove the eight hex-head screws from
the evaporator cover.
Screws
(2 of 8)
Shelf Studs
Evaporator
Cover
6.
Lift and unhook the two evaporator cover
tabs, then lower the cover until the top
edge clears the air duct, and slide the
cover up and out of the freezer.
Unhook Evaporator
7.
To remove the bimetal:
a) Unclip the bimetal from the evaporator
inlet tubing.
b) Follow the instructions that were sup-
plied with the replacement bimetal to
connect the wires.
4-10
Cover Tabs
Bimetal
Clip