Removing The Water & Ice Dispenser - KitchenAid KSSC36FKB00 Technical Education

REMOVING THE WATER & ICE DISPENSER
Electrical Shock Hazard
Disconnect power before servicing.
Replace all panels before operating.
Failure to do so can result in death or
electrical shock.
NOTE: Sharp edges may be present.
1. Unplug the refrigerator or disconnect the
power.
2. Remove the drip tray from the water & ice
dispenser.
Drip Tray
NOTE: There are two types of water and ice
dispensers: one for doors with panels, and the
other for stainless steel trimless doors. The
front panels for each type of door are removed
differently. Refer to step 3 for paneled doors, or
step 4 for stainless steel trimless doors, to
remove either type of front panel.
3. For paneled doors:
a) Partially open the freezer door.
b) Remove the screws from the freezer
door handle and remove the handle.
c) Bow the front panel out at the center
and remove it from the top and bottom
channels of the water & ice dispenser.
Top Channel
Bottom Channel
d) Proceed to step 5 on the next page to
remove the dispenser.
4. For stainless steel trimless doors:
a) Position a wood block along the bottom
edge at the left corner of the water & ice
dispenser.
b) Use a rubber mallet, and hit the block
while you pull out at the bottom, so that
the cover tab releases the panel from
the dispenser housing.
Wood Block
Continued on the next page.
4-23