Wireless Settings Page - AMX NXD-1200V Operation/Reference Manual

If the calibration was improperly set and you cannot return to the Calibration
page (through the panel's firmware); you can access this firmware page via G4
WebControl where you can navigate to the Protected Setup page and press the
Calibrate button through your VNC window.
This action causes the panel to go to the Calibration page seen above, where you
can physically recalibrate the actual touch panel again using the above procedures.

Wireless Settings Page

The Wireless Settings page (FIG. 100) sets the communication information for the installed wireless interface card. This
information includes its corresponding IP communication parameters, wireless communication settings, and read the
device number assigned to the Modero panel. These panels can use the NXA-PCI80211G wireless card for wireless
communication. This card also supports Wired Encryption Protocol (WEP) encryption of 64-bit and 128-bit key lengths.
Refer to both the Wireless Settings Page - Wireless Access Overview section on page 52 and Configuring a Wireless
Connection section on page 53 for more detailed information of setting up the Modero panel for wireless network
access.
FIG. 100 Wireless Settings page (showing default values)
The elements of the Wireless Settings page are described in the table below:
Wireless Settings Page Elements
Back:
Connection Status icon:
IP Settings:
DHCP/STATIC
IP Address
Subnet Mask
NXD/T-1200V Wall/Flush Mount Touch Panel
Red
Blue
Grey
Saves the changes and returns you to the previously active touch panel page.
This visual display of the connection status allows the user to have a current visual update
of the panel's connection status regardless of what page is currently active.
• A Lock only appears on the icon if the panel has established a connection with a
currently secured target Master (requiring a username and password).
Sets the IP communication values for the touch panel and contains:
Sets the panel to either DHCP or Static communication modes.
• DHCP (Dynamic Host Configuration Protocol) assigns IP Addresses to client stations
logging onto a TCP/IP network from a DHCP server.
• Static IP is a permanent IP Address that is assigned to a node in a TCP/IP network.
Note: If DHCP is selected, the following fields become read-only: IP Address, Subnet
Mask, Gateway, Primary DNS, Secondary DNS, and Domain.
Sets the secondary IP Address assigned to the panel.
Sets a subnetwork address to the panel.
• Subnetwork mask is the technique used by the IP protocol to filter messages into a
particular network segment (subnet).
Firmware Pages and Descriptions
IP Settings section
Wireless Settings section
fields are user-editable
fields cycle through choices
fields are read-only
99