Cadillac CTS Owner's Manual page 421

$10araCTS Page 421 Tuesday, September 15, 2009 12:30 PM
NOTICE
If you try to raise the vehicle
with the jack positioned under
the rocker molding, the
molding could break and the
vehicle could be damaged.
Position the jack so that the jack
head will rise to the notch
(inboard of the rocker molding)
in the vehicle's frame.
3. Attach the wheel wrench to
the jack.
- Insert the hook end of the
extension handle into the
jack.
- Insert the flat end of the
extension handle through
the wheel wrench.
4. Place the jack under the
jacking point nearest the tire
you want to change.
You may need to lower the
jack in order for it to fit under
the vehicle.
Section 5
5. Position and raise the jack so
that the slots in the jack head
fit into the metal flange
located behind the arrow on
the plastic molding.
Turn the wheel wrench
clockwise to raise the jack.
6. Make sure the spare tire is
near the flat tire.
7. Raise the vehicle off the
ground until there is room for
the spare tire to fit.
421 . . .
–
–
–
–
–