Ntp Clients - Microsemi SyncServer S200 User Manual

NTP Stratum Change
NTP Leap Change
System Network
System Upgrade
System Config Change
System Health
System Up/Down
System Authentication
Timing No Source
Timing GPS Source
Timing IRIG-B Source
Timing PPS Source
Timing 10MHz Source
Timing GPS Antenna Short
Timing GPS Antenna Open
Timing Oscillator DAC Range
Timing Rubidium Lock
Timing Oscillator Unlock
Timing Source Change
Timing Source Lower Accuracy Input
Timing PLL Unlock
Timing Quality 1e-6
Timing Quality 1e-5
Timing Quality 1e-4
Timing Quality 1e-3
Timing Leap Event
LAN1 Link
LAN2 Link
LAN3 Link
Timing NTP Daemon
System Reset Default Config

NTP Clients

The NTP clients can't reach or synchronize with the SyncServer. On the SyncServer:
The Network LED on the front panel should be green. Otherwise, check the physical net-
n
work port connections. Also see Status LEDs.
Check the configuration of the network ports on the NETWORK - Ethernet page, described
n
in Configuring the Network Ports (on page 112).
If the Sync LED on the front panel is red, the SyncServer is unsynchronized and NTP cli-
n
ents won't synchronize to it. Configure the SyncServer with a valid reference input and/or
997-01520-02 Rev.
X Major
X Notify
X Notify
Minor
Notify
X
Major
X Notify
X Notify
X Major
X
Major
X Notify
X Notify
X Notify
X Major
X Major
Notify
Notify
Notify
Notify
Notify
X Notify
X Notify
X Notify
X Notify
X Notify
X Notify
X Major
X Notify
X Notify
Notify
Notify
G2..........................................................................
Troubleshooting
X X X
X
X
X X X
X
X X X
X
X X X
X X X
X
X
X
X X X
X X X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
Page 117