Caution: Dhcp Not Available; Loggingintothewebinterface; Usingthe1Stsetupwizard; Configuringthe Network Ports - Microsemi SyncServer S200 User Manual

Tasks

CAUTION: DHCP Not Available

If the user selects DHCP, the SyncServer tries to reach a DHCP server for approximately 90
seconds before stopping. Please do not disconnect the power during this time.
ATTENTION : Si l'utilisateur choisit DHCP, le SyncServer essaye d'atteindre un serveur de
DHCP pendant approximativement 90 secondes avant de s'arrêter. Veuillez ne pas enlever
le courrant pendant ce temps.

LoggingintotheWebInterface

1. Get the LAN1 IP address by pressing the STATUS button repeatedly until the LAN1
STATUS screen is visible on the display.
2. Using Internet Explorer, enter the IP address as a URL. This displays the Login page.
3. At the SyncServer Login page, log in. The username is admin and password is sym-
metricom.
Note: When entering the IP address as a URL, leave off any leading zeroes in the IP
address. For example, instead of 192.168.047.025, enter 192.168.47.25.

Usingthe1stSetupWizard

Select the WIZARDS button and complete the 1st Setup wizard.
1. Configure the SyncServer using WIZARDS - 1st Setup. Select the following options:
"Configure Password Recovery" (Ask the IT department for the IP address of the
n
SMTP server).
"Send test mail when finished"
n
"Set Local Time Zone"
n
Note: Reconfiguring LAN1 in the 1st Setup wizard erases the previous network settings for all
Ethernet ports.
Also see WIZARDS - 1st Setup.

Configuringthe Network Ports

Configure the remaining network ports using NETWORK - Ethernet.
Microsemi Recommends:
Using static IP addresses. (See explanation below.)
n
Using Allowed Access to protect the network ports from unauthorized IP addresses or
n
address ranges.
Explanation: NTP associations and authentication may rely on static network addresses. If a
DHCP server assigns a new address to a network port that has DHCP enabled, the asso-
ciations and authentication may stop working.
Also see NETWORK - Ethernet (on page 27).
Page 112..........................................................................997-01520-02 Rev. G2