Porsche 1972 911 Workshop Manual page 88

2, Remove rocker panel cover by
-unscrewing end at front and rear,
-pulling off rubber guard and removing cover for
jack support,
-removing metal screws at top and loosening
metal screws at bottom.
3. Disconnect wires of automatic antenna (optional
extra equipment) inside of car. Unplug antenna
wire on radio; removing right floor plate for this
purpose. Pull both wires out of holes in wheel
well.
4. Disconnect oil lines on pressure relief valve
housing. Catch escaping oil.
5. Disconnect oil lines on cooling coil or at oil
hoses for cars with a front oil cooler. Counterhold
with a second open-end wrench.
6. Unscrew mounting bracket and clamps. Remove
oil lines.
I n s t a l l i n g
1 . When installing new lines in'cars without side
-turn signals proceed as follows with the mounting
points in the wheel well,
Point A Is still applicabbe.
Point B+C Not applicable; plug with 6
hex. head bolts used in conjunction
with a body sealing compound.
New (drill a 5
Point D
from wheel house/floor plate joint
and 75 mm/3 in. from fender joint
plate).
x
10 mm
dia. hole 255 mm/lO in.