Table of Contents
Advertisement
1. Drive shift detent securing roll pins out.
2. Drive half-round dowel pin out.
N o t e
Detent components are under spring tension.
Therefore, always remove the roll pin first,
then the half-round dowel pin.
Heat gear housing to approximately 120°c
3.
using special tool US 8050.
,
D I S A S S E M B L I N G A N D A S S E M B L I N G
g
outer races out
A s s e m b l i n g
1. Heat housing t o approximately 1 2 0 ~ ~
with special tool US 8050.
C a u t i o n
T h e bearing outer races differ in inside dia-
meter. The race with the larger inside diameter
belongs to the pinion shaft (lower shaft).
2. Install 5th and reverse speed shift rod.
Insert long detent and drive roll pin in.
3.
Hide quick links:
Advertisement
Table of Contents
