Porsche 1972 911 Workshop Manual page 634

I N S T A L L I N G D O O R W I N D O W L I F T C H A N N E L
A s s e m b l i n g
1. P l a c e door window on soft m a t e r i a l and r e -
m o v e grease from low- edge.
2. Use new rubber insert. Part
and fit i t on window glass t o m a t c h lift c h a n -
n e l .
N o t e
C l e a n rubber insert with a c e t o n e before installing.
If wax coating is not c l e a n e d off, window glass
could disengage from lift channel.
3. Press i n window lift.channe1.
N o t e
T h e window lift c h a n n e l of a c o u p e must b e
installed so that t h e channel begins
hind e d g e of glass.
T h e window lift channel of a T a r g a must b e
installed so that t h e glass fits fully in t h e plastic
guide.
Window l i f t channels must b e pressed in a l l t h e
way over their e n t i r e length. Light taps applied
t o t h e channels while pressing t h e glass i n will
f a c i l i t a t e installation.
P l a c e window in door and c o a t sliding surfaces
4.
of window regulator with a multi- purpose
grease.
No. 9 0 1 542 491
m m b e
88
-
C o u p e window glass
T a r g a window glass