Porsche 1972 911 Workshop Manual page 615

Description
Front bumper
Grommet
Nut, M 8
Washer
Sheetmetal nuts,
4.2 m m
Bumper strip
Bumper strip plugs
S h e e t m e t a l screws.
4.2
Directional signal
l a m p
S i d e cover
Washer
Nut, M 5
Self- tapping nuts
Sealing strip
S h e e t m e t a l screw
S h e e t m e t a l nut,
4.8 m m
Washer
Rubber washer
Note when:
removing installing
Flanged studs of d e -
formation t u b e must fit
into cutouts. Sealing
strip must fit alround.
Use self- locking nuts.
Detach side and pull Press into grommets
off. bolt sides on.
Replace if necessary
Replace if necessary
Check for equal spacing
Remove bumper, t a k e
out through back
Check far equal spacing
Use self-locking nuts
Remove self- tapping Attach t o bumper
nuts from skirt
Fit well along t h e
fender
Replace if necessary
Use in t h e area of t h e
lock transverse panel
Remarks