DISASSEMBLING AND ASSEMBLING MANUAL T R A N S M I S S I O N
D i s a s s e m b l i n g
1. Block input shaft with special tool P 37a,
engage 5th gear.
2. Remove castellated nut from input shaft,
and flange nut from pinion shaft.
.
,
Mark needle bearing of 5th speed free gear;
3.
it must be reassembled with same gear.
M a n u a l T r a n s m i s s i o n
4. Remove guide fork cover with gasket.
5. Remove nuts from gear housing. Pull housing
and selector fork rod (5th and reverse speed),
and selector fork rod with selector shaft off
the studs (tap lightly with a plastic mallet,
if necessary).
N o t e
Selector fork rod for 5th and reverse speed must
be in neutral. Otherwise the gear housing will
bind against the rod and cannot b e removed.
911