Porsche 1972 911 Workshop Manual page 910

b e g i n n i n g w i t h 1 9 7 4 M o d e l s
.
1 Mark and drill nozzle mounting holes in
bumper. T o locate hole centers place the
rubber grommet on the bumper. Note that
the nozzles and rubber grommets a r e
different for left and right sides.
The spray jets are positioned slightly off center
(of headlight) the distance between jets
mm (49 1 / 4 in.)
1250
2. Remove bumper. If an angle drill motor is no}
available, the front apron will also have to
b e removed.
Drill 25 m m (1 in.) hole for water feed hose
3.
and insert grommet. (Be careful not to damage
hoses in this area of cars equipped with an
air conditioner.)
S e r v i c e I n s t a l l a t i o n o f H e a d l i g h t W a s h e r s
is
E l e c t r i c A c c e s s o r i e s