Speakers - HP Envy 17-da0 Series Maintenance And Service Manual

3. Remove the fans (3) from the computer.
To install the fans, reverse this procedure.

Speakers

To remove the speakers, use this procedure and illustration.
Table 5-7 Speaker description and part number
Description
Speaker Kit
Before removing the speakers, follow these steps:
1. Prepare the computer for disassembly (see
2. Remove the bottom cover (see
3. Disconnect the battery cable from the system board (see
Remove the speakers:
1. Disconnect the speaker cables (1) from the system board.
2. Remove the two Phillips M2.0 × 2.0 screws (2) that secure each speaker to the computer.
3. Lift the speakers (3) out of the computer.
NOTE:
screw holes. The absence of or damage to these isolators can result in degraded speaker
performance.
Bottom cover on page
When removing the speakers, make note of the location of the four rubber isolators in the
Preparation for disassembly on page
29).
Battery on page
Spare part number
N87232-001
29).
31).
Speakers 39