Removal And Replacement Procedures For Authorized Service Provider Parts; Component Replacement Procedures; Base Enclosure - HP OMEN Maintenance And Service Manual

6 Removal and replacement procedures for
authorized service provider parts
CAUTION: Components described in this chapter should be accessed only by an authorized service provider.
Accessing these parts can damage the computer or void the warranty.

Component replacement procedures

NOTE: Details about your computer, including model, serial number, product key, and length of warranty,
are on the service tag at the bottom of your computer. See
NOTE: HP continually improves and changes product parts. For complete and current information on
supported parts for your computer, go to http://partsurfer.hp.com, select your country or region, and then
follow the on-screen instructions.
There may be as many as 85 screws that must be removed, replaced, and/or loosened when servicing the
parts described in this chapter. Make special note of each screw size and location during removal
and replacement.

Base enclosure

Description
Base enclosure in Twinkle Black
Before removing the base enclosure, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
3. Disconnect all external devices connected to the computer.
4. Remove the following components:
Service door (see
▲
Remove the base enclosure:
1. Remove the two hinge screw covers (1), two back screw covers (2), and two side screw covers (3).
Service door on page 29)
Labels on page 15 for details.
Component replacement procedures
Spare part number
862961-001
33