Parameters Of Thermal Continuous Paper; Parameters Of Marked Paper - SNBC BTP-L580IIC User Manual

2.3.2

Parameters of thermal continuous paper

Paper type: Thermal continuous paper
Paper supply method: Paper roll
Paper width: 54.5±0.5 mm~82.5±0.5 mm
Paper thickness: 0.06mm-0.1mm
Thermal layer: Outward
Paper roll specifications: OD(MAX): ф100 mm
Recommended paper:
2.3.3

Parameters of marked paper

BTP-L580IIC can support marked paper printing and set the cutting and initial printing position
accurately. Marked paper not only should meet the parameters of thermal paper roll, but also
should meet the following requirements:
L1 mark height: 3mm≤L1≤13mm
L2 mark length: L2≥12mm
L3 mark spacing: 20mm≤L3<500mm
Mark position: The mark can be set on the left, middle or right, and when it is on the left or
right, only 80mm paper is available.
Reflectivity: The reflectivity of the marked part must be no more than 15% while the reflectivity
of the rest part should be higher than 85%. There should be no patterns like advertisement or
poster between two marks.
Caution:
To ensure quality print and normal lifetime, use recommended paper or its equivalent;
Paper cannot be stuck on the paper roll core;
If the paper is contaminated by chemical substances or grease, the contaminated part
may fade or be printed unclearly;
Paper model
F240AC,F220-VP,FV230A1
PA220AG,HP220A
FD210,PD150R,PD160R
F70NA
Manufacturer
Mitsubishi Paper Mill CO., LTD
OJI Paper CO., LTD.
FUJI PHOTO FILM CO., LTD
- 4 -
BTP-L580IIC User's Manual