Appearance And Modules - SNBC BTP-L580IIC User Manual

3 Appearance and modules

3.1 Appearance and modules
1—paper guide
2—paper near end sensor lever
3—mark sensor
4—platen roller
5—cutter
6—cutter cover board
7—tear-off bar
8—fixed blade
9—print head
10—guard board for print head
11—roller
12—cover open lever
13—top cover
14—middle cover
15—bottom cover
16—thumb wheel
17—power switch
18—power interface
19—communication interface
20—USB interface
21—cash drawer interface
22－POWER LED
23－ERROR LED
24－PAPER LED
25－FEED button
Functions of some modules:
a) Paper guide
Move the paper guide in paper cabinet continuously by turning the thumb wheel so as to
adapt to various paper width 54.5±0.5 mm~82.5±0.5 mm.
b) Power switch
Press down "O" to turn off the printer and press down "—" to turn on the printer.
c) FEED button
Power on the printer while the FEED button is pressed down, and then release the
button. The printer will print out a selection page.
1) If selecting "Print Self Test", the printer will print out configuration information. After
the printing, the printer will print a character test sample if pressing down the FEED
button for a short time, and the printer will enter button configuration mode(Parameter
setting (configuring) by Feed button) if pressing down the FEED button for a long time.
- 6 -
BTP-L580IIC User's Manual