Quick Installation Overview; Installing A Wilson Electronics Outside Antenna - Wilson Electronics 271201 Installation Manual

Quick Installation Overview

Installation Diagram
Cell Phone
Notebook
DC Power

Installing a Wilson Electronics Outside Antenna

To receive the best cell signal, select a location in the center of the vehicle's roof 12 inches
away from any other antennas or windows .
Follow the specific antenna installation instructions included with the outside antenna .
Magnet - Mount
Antenna Shown
Part #301103
Carefully
Pull Down
Door Seal
Tuck Cable
Under Seal
Contact Wilson Electronics's Technical Support Team with any questions at 866-294-1660
Or email: tech@wilsonelectronics.com
Outside
Antenna
PDA
Supply
Signal
Booster
The outside antenna must be installed
vertically . Signal performance will be
degraded if the antenna is not vertical .
The antenna cable may run through the
door to the Signal Booster .
For a more professional looking installation,
run the antenna cable under the door seal .
The antenna cable is small enough to easily
Run Cable tuck under the door seal or plastic molding .
Under Seal
Carefully pull down the door seal . Run the
cable through the seal and push the seal
back into place . This prevents constant
wear and tear on the cable as the door
opens and closes .
!
!
!
Inside
Antenna
!
Warning: The outside antenna must have
a separation of at least 20 inches from all
persons during normal operation .
Warning: Do not use any type of glass-
mount antenna with this Signal Booster .
The outside and inside antennas must
be shielded from each other to prevent
oscillation (feedback) .
Hours: 7am to 6 pm MST.
Warning: In a wire-
less installation, do
not plug the Signal
Booster directly into
the cell phone and/
or data card using an
antenna adapter . It
will damage the Signal
Booster, cell phone
and/or data card
.
Warning: Do not plug
in the DC power supply
until the outside and
inside antenna cables
are attached to the
Signal Booster .
2