Wilson Electronics AG Pro 75 Installation Manual page 15

is blinking until you get a blinking green light . The booster is
now working with reduced gain . If the gain is not adequate for
good coverage, you will need to turn the gain to maximum and
then turn the outside antenna away from the cell tower until the
light turns to blinking green . If the booster will not respond turn
the gain down 5 dB and move the outside antenna, continue
to adjust the gain and the antenna position until the light turns
blinking green . Contact Wilson Electronics Technical Support
Team for assistance: 800-204-4104 .
3. SOLID RED
If either of the two lights on the signal booster are solid red,
this indicates that the signal booster has shut down on that
frequency to prevent an oscillation . First, make sure that all
the connections are tight . Then reduce the gain of the booster
in small increments by rotating the gain control, counter
clockwise, wait 5 seconds between each adjustment for the
booster to reset, continue this adjustment until the light turns
green . When you are turning down the gain, you are reducing
the inside coverage area . If the amount of coverage area is
sufficient for your needs and the light is green the installation
is complete . If the coverage area is not large enough, it is
necessary to increase the separation distance of the antennas
by moving them horizontally or vertically farther apart, or both .
If after separating the antennas your coverage area is still too
small, contact Wilson Electronics Technical Support Team for
assistance: 800-204-4104 .
If your installation takes longer than 15 minutes, it is possible
to re-enter the installation mode by disconnecting and
reconnecting the power supply from the signal booster .
SOLID GREEN
The indicator lights on the signal booster will be a solid green
after the first 15 minute installation period, and the unit is
powered up and working properly .
Contact Wilson Electronics Technical Support Team with any questions at
or email:
14