Table of Contents
Advertisement
Easy Installation
Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660 .
1 .
Select a location to install the signal booster that is away from excessive heat, direct
sunlight, moisture and has proper ventilation . Do not place the signal booster in an
air-tight enclosure .
2 .
Select a location on the roof of the building to install the outside antenna . Use a cell phone
in test mode to find the strongest signal from the cell tower . Visit www .wilsonelectronics.com
to find test mode function for your particular cell phone .
3 .
Select a location for the inside antenna, preferably in the center of where the signal
needs to be amplified . Separation distance between inside and outside antennas must
be a minimum of 50 feet .
4 .
Run the outside antenna cable to the signal booster and attach it to the connector
labeled "outside antenna" on the signal booster . Run the inside antenna cable to the
signal booster and attach it to the connector labeled "inside antenna" on the signal
booster . Note: Be careful when plugging the connector in so as not to bend the center
pins on the connectors.
5 .
Verify that both the outside antenna and the inside antenna are connected and check
that all connections are tight, before powering up the signal booster . Lightning surge
protection is recommended for all in-building installations .
6 .
AG Pro 75™ Signal Booster has been packaged with the gain control knobs adjusted
to the highest gain position . If one or both of the lights are blinking red please refer to
page 4 .
7.
Warning:
Connecting the signal booster directly to a cell phone with use of an adapter
will damage the cell phone .
Outside Antenna
Inside Antenna
Typical Installation
Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660
or email: tech@wilsonelectronics.com. Hours: 7 am to 6 pm MST.
Minimum separation
distance 50 feet
Lightning
Surge Protector
Signal
booster
Power
Supply
2
Advertisement
Table of Contents
