Environmental Requirements - SMART Board SB800ix2 Configuration And User's Manual

IMPORTANT INFORMATION
output connector to provide power to other SMART products, you may need to purchase third-
party adapters.
Keep your remote control in a safe place because there is no other way to access menu
l
options.
Do not disconnect cables from the ECP to connect peripheral devices because you could
l
disconnect controls for your interactive whiteboard.
Disconnect the product from its power source when it's not used for a long period.
l
Other precautions
If you own a SMART product other than a SMART Board interactive whiteboard system, refer to the
installation manual for your product for relevant warnings and maintenance instructions.

Environmental requirements

Before you install your SMART Board interactive whiteboard system, review the following
environmental requirements.
Environmental
requirement
Operating temperature
Storage temperature
Humidity
Water and fluid
resistance
Dust
iv smarttech.com/kb/170340
Parameter
41°F to 95°F (5°C to 35°C) from 0' to 6000' (0 m to 1800 m)
l
41°F to 86°F (5°C to 30°C) from 6000' to 9800' (1800 m to 3000 m)
l
-4°F to 122°F (-20°C to 50°C)
l
5% to 95% storage relative humidity, non-condensing
l
5% to 85% operating relative humidity, non-condensing
Intended for indoor use only. Doesn't meet any salt-spray or water
l
ingress requirements.
Don't pour or spray liquids directly onto your interactive whiteboard,
l
the projector or any of its sub-components.
Intended for use in office and classroom environments. Not for
l
industrial use where heavy dust and pollutants can cause
malfunctions or impaired operation. Periodic cleaning is required in
areas with heavier dust. See Cleaning the projector on page 21 for
information on cleaning the SMART UX80 projector.