SMART Board SB800ix2 Configuration And User's Manual page 82

APPENDIX C
ADJUSTING PROJECTOR SETTINGS
Setting Use
Native DLP Selects 16:10 or 16:9.
Resolution
Network menu
Network Activates the projector's RJ45
connector and network
features.
Status Displays the current network
status (Connected,
Disconnected or Off).
DHCP Displays the status of the
network's Dynamic Host
Configuration Protocol (DHCP)
as On or Off.
Password E-mails the network password
Reminder to the predefined e-mail
recipient.
IP Address Displays the projector's current
IP address in values between
0.0.0.0 and 255.255.255.255.
Subnet Mask Displays the projector's subnet
mask number in values
between 0.0.0.0 and
255.255.255.255.
72 smarttech.com/kb/170340
Notes
The default is 16:10, which is the correct
setting for SMART Board 885 interactive
whiteboards.
This option is only available on
SMART UF75w projectors with DDP fimrware
version 0.0.2.1 or later.
When you select 16:10, the projector's native
resolution is 1280 × 800.
When you select 16:9, the projector's native
resolution is 1280 × 720.
The default is off.
The default is on.
On enables a DHCP server on the network to
automatically assign an IP address to the
projector.
Off enables an administrator to assign an IP
address manually.
See Web page management on page 41 to set
up a destination e-mail address.
To change the projector's IP address, use the
RS-232 connector or use a DHCP server to
assign a dynamic IP address, and then set a
static IP address using the network remote
management feature (see Remotely managing
your system through a network interface on
page 41).