Using Your Interactive Whiteboard; Using The Extended Control Panel (Ecp) - SMART Board SB800ix2 Configuration And User's Manual

CHAPTER 3
USING YOUR INTERACTIVE WHITEBOARD SYSTEM
NOTE
The Mute, Volume Up and Volume Down buttons work only if there is an audio source connected
to the projector for the selected video input source.
For information on using the remote control's Menu button to adjust the projector settings, see
Adjusting projector settings on page 67.

Using your interactive whiteboard

For information about how to use your interactive whiteboard, refer to the SMART Board 800 series
interactive whiteboard user's guide (smarttech.com/kb/144817).
When you connect your SMART Board interactive whiteboard to a computer with SMART software,
you can access the full capabilities of your interactive whiteboard.
For more information on this software, press the Help button on your interactive whiteboard pen tray.
For additional resources, go to smarttech.com, click the flag icon in the top-right corner, and then
select your country and language. In the Support section of this website, you'll find up-to-date,
product-specific information, including setup instructions and specifications.
The SMART training website (smarttech.com/training) includes an extensive library of training
resources you can refer to when first learning to set up or use your interactive whiteboard system.

Using the Extended Control Panel (ECP)

The ECP gives you control of the basic operations of your interactive whiteboard system. Press the
Power button on the ECP or remote control to put the projector system into Standby mode or turn
it on. Press the Input button on the ECP or remote control to switch sources on the projector.
IMPORTANT
Keep your remote control in a safe place because there is no other way to access menu
l
options.
Do not disconnect cables from the ECP to connect peripheral devices because you could
l
disconnect controls for your interactive whiteboard.
15 smarttech.com/kb/170340