Service And Support Controls - SMART Board SB800ix2 Configuration And User's Manual

APPENDIX B
REMOTELY MANAGING YOUR SYSTEM THROUGH AN RS-232 SERIAL INTERFACE

Service and support controls

These commands control the integration properties of the projector.
Usable command by Property
power state
Standby / On
idle
get modelnum
get prjserialnum
get get fwverddp
get get fwvermpu
get get fwvernet
get get fwverecp
set or get set or get lamphrs
get get syshrs
get displayhour
60 smarttech.com/kb/170340
Valid values
[model name text string]
B01#??##?####
(13-digits, # is any
number, ? is any letter)
#.#.#.#
#.#.#.#
#.#.#.#
#.#.#.#
0~5000
0~20000
0~20000
Notes
The projector's model.
The projector's serial
number.
Firmware version for the
projector's digital display
processor.
Firmware version for the
projector's microprocessor
unit.
Firmware version for the
projector's network module. If
the network module is
disabled, this will report as
0.0.0.0.
Firmware version for the
attached ECP (extended
control panel). If no ECP is
attached to the projector, this
will be 0.0.0.0.
Current record of the age of
the projector lamp in usage
hours.
Current record of the age of
the projector in usage hours.
Current record of the age of
the projector in usage hours.