Resetting The Lamp Hours - SMART Board SB800ix2 Configuration And User's Manual

CHAPTER 4
MAINTAINING YOUR INTERACTIVE WHITEBOARD SYSTEM

Resetting the lamp hours

After you replace the lamp module, you need to access the projector service menu to reset the lamp
hours. To prevent accidental errors, only a system administrator should perform this procedure.
NOTE
Always reset the lamp hours after you replace the lamp, because lamp service reminders are based
on the current hours of use.
To reset the lamp hours
1. Using the remote control, press the following buttons quickly to access the service menu:
Down, Up, Up, Left, Up.
CAUTION
Do not adjust any settings in the service menu other than those listed in this guide. Changing
other settings can damage or affect the operation of your projector and may invalidate your
warranty.
2. Scroll down to Lamp Hour Reset and then press Enter.
CAUTION
Do not reset the lamp hours unless you have just replaced the lamp module. Resetting the
lamp hours on an old lamp can damage your projector as a result of lamp failure.
3. Scroll down to Exit and then press Enter to exit the projector service menu.
23 smarttech.com/kb/170340