APPENDIX B
REMOTELY MANAGING YOUR SYSTEM THROUGH AN RS-232 SERIAL INTERFACE
Power state controls
These commands put the projector in and out of Standby mode and request the projector's current
power state. The projector's power state determines whether certain commands are available at that
time. These settings are available even when the projector is in Standby mode.
Usable command by
Property
power state
Standby
On
/ idle
get
get
powerstate
set or get set or get
statereporting
55
smarttech.com/kb/170340
Valid values
• on
• off
• confirm off
• powering
• cooling
• idle
• on
• off (default)
Notes
These states may be reported
asynchronously, preceded by
a # character, if the projector's
"statereporting" function is
enabled.
Causes the projector power
state to be reported
asynchronously, without a
need to get it first.