Gas Tank - Arctic Cat 2012 DVX 90 Service Manual

FOR ARCTIC CAT ATV DISCOUNT PARTS CALL 606-678-9623 OR 606-561-4983
2. Turn the idle adjustment screw in or out until the
engine idles at 1700 RPM.
! WARNING
Adjust the idle to the correct RPM. Make sure the engine
is at normal operating temperature before adjusting the
idle RPM.

Gas Tank

! WARNING
Whenever any maintenance or inspection is made on
the fuel system during which there may be fuel leakage,
there should be no welding, smoking, open flames, etc.,
in the area.
REMOVING
1. Turn the gas tank valve to the OFF position.
2. Remove the gas hose from the carburetor by remov-
ing the spring clamp; then funnel the gas hose into an
appropriate container of sufficient size to catch all
the gas from the gas tank.
3. Turn the gas tank valve to the RES position and drain
the gas from the gas tank.
4. Remove the seat.
5. Remove the top handlebar caps.
6. Carefully lay the handlebar assembly forward on the
front fender panel.
50
www.mymowerparts.com
 NOTE: To access the gas tank, it is necessary to
move the front fender panel, which requires removing
the handlebar from its clamp. However, the levers,
controls, cables, and wires do not need to be discon-
nected. The front fender panel and handlebar assem-
bly can be tilted forward far enough to gain access to
the gas tank.
7. Remove the four Phillips-head cap screws and six
nuts securing the front fender panel. Account for
eight washers.
8. Remove the gas tank cap; then tilt the front fender
panel and handlebar forward.
9. Remove the two cap screws securing the gas tank;
then lift the gas tank and secure it out of the way.
YT015B
10. Remove the gas hoses from the gas tank valve noting
where each one is attached.
 NOTE: Mark the gas hoses for assembling pur-
poses.
MD2139
Manual
Table of Contents
MD2393
MD1865
MD1848